Only half my devices start and have telnet

@Minit55 wrote:

I have a very strange issue.

I´m int the pert 5 of the beginners guide. (just to give more info, i just installed VIRL for the first time last night).

Im running VM workstation version: 10.0.7 build-2844087
I got the VIRL 1.0.0 and the install process went excatly how it was supposed to.
i have 4 cpus and 8 gig ram allocated.

I have been following the part 1-5 of the beginners guide. And whan i try to start the sx routers they all become active.

However, the guide says to open the London router and watch the boot and OSPF, and i simple get a blank console window.

Then just for the test i try opening all of them, and the brussels and paris router works like it should i can telnet, en, sh run etc.

I tried mgmt access to the london via SSH:telnet 10.255.0.21
guest@mgmt-L2my_O$ telnet 10.255.0.21
Trying 10.255.0.21...
telnet: Unable to connect to remote host: No route to host

I tried to ping the IP but does not work.

I took a look at the overview as i did in one of the previous steps of the beginners guide, and to me it looks fine.

Can anybody help ?

UPDATE. while typing this topic i realized that all the devices was booting in sequence. !

I guess i need to wish for more ram for X-mas

Have taken around 25 minutes too boot 6 devices. !!! ( is this purely a ram problem or also CPU related ) ?????

Posts: 1

Participants: 1

Read full topic